Holley Sniper EFI: How to Set Idle

This video shows you how to set the initial startup idle or if you want to reset your Holley Sniper EFI and reset the idle as well.

This is done on my 1990 Third Gen Chevy Camaro with a Small block Chevy 350 with flowmaster 40 series mufflers and a b&m shifter as well as the Holley Sniper EFI and the Holley Hyperspark ignition system

1. Make sure the engine is warmed up to at least 160 degrees before adjusting.
2. Slowly move the idle screw in or out on the Holley Sniper until the IAC(Idle Air Control) reads between 2-10%
3. Cycle the ignition so the TPS ( Throttle Position Sensor resets)

More videos coming about the Sniper EFI and the Hyperspark ignition system!

Holley Sniper EFI on Amazon:
https://amzn.to/3m1MIBr

Видео Holley Sniper EFI: How to Set Idle канала Zanes Garage