Here 2 GPS UAVCAN Setup Info For Cube Autopilot ProfiCNC HEX Aero & Pixhawk

Showing you how to setup the Here 2 GPS on UAVCAN on the Cube Autopilot.

You can order this from https://www.3dxr.co.uk/

Settings you need to change is
CAN_P1_DRIVER to 1
GPS_TYPE to 9
NTF_LED_TYPES enable UAVCAN.
I would like to thank https://www.3dxr.co.uk for very Kindly sending this over to us to take a look at, if your looking to order the Herelink or Pixhawk or party for your drone plate do check them out.

Finally I have been asked for other ways for users to support and they are listed below too.

Support us on Patreon https://www.patreon.com/MadRC

Paypal Donate mad_rc@icloud.com

Above are some affiliate links to the products seen in this video and some trusted vendors. If you have found the video useful I would be grateful for your support by purchasing via these links, this ads no additional cost to you and it help us to keep making videos like this one. While we have now started to use YouTube advertising it’s you purchasing via these links that allows me to keep buying new products to talk to you about.

Having advertising income via YouTube and these links is the only way we fund the channel and like many of the other smaller YouTube creators we do not make a profit and all proceeds go back into making content to share with you.

Thank you for your support and again please do Subscribe, Like and Share.

#Herelink
#Hexaero
#TheCube
#Ardupilot
#Pixhawk

Видео Here 2 GPS UAVCAN Setup Info For Cube Autopilot ProfiCNC HEX Aero & Pixhawk канала Mad's Tech