HX711 with a Four Wire Load Cell and Arduino | Step by Step Guide.

In this video, I explain how to connect a four-wire load cell to the HX711 amplifier module and how to read the weight value with an Arduino.

My article about the HX711 amplifier module and how to connect a four-wire load cell to it:
https://circuitjournal.com/four-wire-load-cell-with-HX711

Github page of the "HX711_ADC" library:
https://github.com/olkal/HX711_ADC
Buy from Amazon :
Crimping tool: https://amzn.to/2B9dJRk
DuPont connector set: https://amzn.to/3e1GApq

Load Cell with HX711: https://amzn.to/2zwTcG1
Genuine Arduino Uno: https://amzn.to/2ZXfdsr
Male to male jumper wires: https://amzn.to/2TX0GZP
(As an Amazon Associate I earn from qualifying purchases)
Buy from Banggood:
Load Cell with HX711: https://www.banggood.com/custlink/GG3GTykjso
Arduino Uno clone: https://www.banggood.com/custlink/K33G2p0Vi5
Male to male jumper wires: https://www.banggood.com/custlink/Dm33UrBo8a
Disclosure: Bear in mind that some of the links in this post are affiliate links and if you go through them to make a purchase I will earn a commission. Keep in mind that I link these companies and their products because of their quality and not because of the commission I receive from your purchases. The decision is yours, and whether or not you decide to buy something is completely up to you.
Music from Youtube audio library.

Видео HX711 with a Four Wire Load Cell and Arduino | Step by Step Guide. канала Indrek