Making a Branding Iron - My Makers Mark

My new channel logo carved into 10 mm thick steel to form a branding iron. The thicker material has more mass and holds the heat longer. It takes a while to heat up, but is good for branding stuff in batches.

This would nowadays be the task of a CNC, or even a metal mill, but since I don't have one, I carved it with a Dremel tool on a piece of scrap. The whole project took less than 4 hours. I used only zip-cut discs to trace the outlines and hollow out the parts in between.
------------------------------------------------------------------------------------------------------------
Soundtracks:

H-LR - "End of the Line"
licensed under a CC Attribution License.
downloaded from Free Music Archive
http://freemusicarchive.org/music/H-LR/End_of_the_Line/01-End_of_the_Line

Jahzzar - "money" and "Nightmare"
under a CC Attribution-Share Alike 3.0 International License
downloaded from Free Music Archive
http://freemusicarchive.org/

Видео Making a Branding Iron - My Makers Mark канала FinnCrafted