$200 FPV Drone Build & Set Up! - The Rotor Riot Budget Build

This is the new Rotor Riot budget build! You can get this kit for just $200. However these are not cheap parts. These are parts that we worked to source at a low cost so that we can create a kit with a killer price. This drone features the Oscar Liang RunCam camera, a TransTec F7 Flight Controller, Hypetrain Motors, and 3D printed parts to make this build super clean.

Get the kit HERE: https://rotorriot.com/collections/pre-built-quads-2/products/cl1-budget-built-kit

For a bit extra, you can have the build put together for you: https://rotorriot.com/collections/pre-built-quads-2/products/cl1-budget-build-built-and-tuned

Full Build Manual: COMING SOON

If you pin position the 4-in-1 ESC and pin the harness exactly as shown in this video, here are motor remap CLI commands

resource MOTOR 1 C07
resource MOTOR 2 C06
resource MOTOR 3 B01
resource MOTOR 4 B00

(ALWAYS verify correct motor re-mapping with the PROPS OFF! If the above map does not work for you then you have positioned your ESC differently or swapped ESC signal wires, but this is okay! Just follow the process shown in the video to create CLI commands that will work)
Here is the complete CLI dump that will configure all the settings shown in this video for BF4.0: https://docs.google.com/document/d/1RgRDmhIp8KQk96ilump9kgxc5ITO4ieVIspPgW1W2ug/edit?usp=sharing

CLI dump for BF4.1: COMING SOON
Subscribe to my Main Channel: https://YouTube.com/LeDribFPV
Subscribe to Rotor Riot: https://YouTube.com/RotorRiot

Видео $200 FPV Drone Build & Set Up! - The Rotor Riot Budget Build канала Drib 2