Proper RFD900+ cable connection to Pixhawk
In this video we clarify how to connect the Pixhawk to RFD900 cable to ensure that it is connected correctly and not backwards. Note that when powering the RFD900 from the Pixhawk it is recommended to limit the power output to 500mW or less (setting of 27). If full power (setting of 30) is desired, please remove the jumper and connect a UBEC such as the 5V unit that we sell.
Best regards from http://www.helibatics.com
Видео Proper RFD900+ cable connection to Pixhawk канала HeliBaticsTV
Best regards from http://www.helibatics.com
Видео Proper RFD900+ cable connection to Pixhawk канала HeliBaticsTV
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
RFD900 Connected To Pixhawk 2 And Powered By External 5V BECModern PixHawk Telemetry Radios: Options for telemetry and setup tipsFrSky Taranis X9D Gimbal PR10 - reconfiguring for throttle4G (LTE) Telemetry and Control of Pixhawk using Pi3INTERFACING RFD900 TELEMETRY WITH 3DROBOTICS PIXHAWKRFD config 2Make Camera Trigger Cable For Sony Alpha Series Cameras And Setup with Pixhawk5 причин не использовать ЭТИ светодиоды(1/5) PixHawk Video Series - Simple initial setup, config and calibrationRFD configGround station (Part 2) - my current setupAlta X RFD900 Mod walk throughWiring & Connections Of Pixhawk With Peripherals : Arduplane🆕WIRELESS 433MHz Aircraft Control & Telemetry- iNav 3DR Radio WORKS! 📡👍How to bind FrSky V8-II series Rx (V8FR-II, V8R7-II, V8R4-II) to XJT moduleHow to program FrSky SBUS/CPPM decoder with SBUS Channel ChangerMAUCH PL Series BEC & Current Sensor for Pixhawk & Cube AutopilotsRFDesign RFD 900 & 868 Long Range Telemetry For Ardupilot & PX4RFD900X Telemetry+RC(PPM)...17km , 100mW test1 (NO ANTENNA High Gain)Taranis X9D 6-position switch programming