#11: Tektronix Oscilloscope Triggering controls and their usage
This video describes the Triggering controls on a typical Tektronix analog oscilloscope. Other analog scopes will typically be similar. The video presents the Trigger Level, Slope, Source, Coupling, Mode and Holdoff controls, and how each of them are used and their affect on the triggering capability of the scope.
Видео #11: Tektronix Oscilloscope Triggering controls and their usage канала w2aew
Видео #11: Tektronix Oscilloscope Triggering controls and their usage канала w2aew
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Introduction to oscilloscopes
EEVblog #159 - Oscilloscope Trigger Holdoff Tutorial
Tektronix 465 Oscilloscope Testing
#90: Measure Capacitors and Inductors with an Oscilloscope and some basic parts
Oscilloscope Triggering Techniques:- how to trigger a scope
Tektronix 7A13 Differential Comparator Repair
Junk Box Oscilloscope, Can It Be Fixed?
Tek 465 Repair
Tektronix 2235 - 100Mhz Dual Trace, Dual Time Base Oscilloscope
Tektronix 464 storage modes
Oscilloscope Basics, Part 1: Discussion, Y-Axis (Voltage) Controls, Probe Calibration
#43: Analog Oscilloscope Basics: Making a Frequency Measurement
EEVblog #279 - How NOT To Blow Up Your Oscilloscope!
How to Set Up Oscilloscope Triggering (Part 1: Edge Triggering)
#9: Basic 1X and 10X Oscilloscope Probe tutorial
A Visit to the VintageTek Museum
Tektronix 2465A oscilloscope demonstration
#25: Analog Oscilloscope bandwidth considerations
Tektronix 465 Dual Trace & Dual Time Base Oscilloscope
BK Precision 2120 Oscilloscope Repair - No Sweep