2007 R6s Engine Rebuild
After months of hard work, the 2007 Yamaha R6s rebuild finally comes to and end. From spilling fuel to slipping on WD40, an EXTREME amount of effort was put into rebuilding. Lots of coffee and ridiculous amounts of hours from day in to day out during weekdays and weekends, Papa Johns Pizza four times a week on average just so no unnecessary time is spent cooking. Keeping up with school while doing this was a well deserved challenge. The motorcycle had 72,000 miles on it and the engine took a beating and read low compression. So of course, I grabbed a load of tools and ripped everything apart to spec out every component. ENJOY!
Things done:
Valve Replacement
Valves Shimmed
Valves Lapped
Fuel Pump Replaced
Compression Tested
Spark Plugs
Coils
Cylinders Honed Crosshatched at 45 degrees
Oil Seal
Piston Rings
Rod Bolts
Journal Bearings
Carbon Removal
Head Gasket
Valve Cover Gasket
Clutch Disks
Clutch Boss
Clutch Springs
Front and Rear Wheel Bearings
Ignition Switch
All Fluids Flushed
Pirelli Diablo Rosso 2 (Front) 3 (Rear)
RK Chain, Steel Sprockets (Front 1 tooth down)
Видео 2007 R6s Engine Rebuild канала sagar sharma
Things done:
Valve Replacement
Valves Shimmed
Valves Lapped
Fuel Pump Replaced
Compression Tested
Spark Plugs
Coils
Cylinders Honed Crosshatched at 45 degrees
Oil Seal
Piston Rings
Rod Bolts
Journal Bearings
Carbon Removal
Head Gasket
Valve Cover Gasket
Clutch Disks
Clutch Boss
Clutch Springs
Front and Rear Wheel Bearings
Ignition Switch
All Fluids Flushed
Pirelli Diablo Rosso 2 (Front) 3 (Rear)
RK Chain, Steel Sprockets (Front 1 tooth down)
Видео 2007 R6s Engine Rebuild канала sagar sharma
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
YAMAHA R6 Engine Tear DownWhat goes inside a Yamaha R3 Superbike engine [Superbike Build Series Ep.4]Understanding Motorcycle ClutchDESARMAR MOTOR R6RHow To Fix Engine Hesitation During Acceleration - Easy Fix!The R1 engine is TOAST!CBR EP2- transmission repairStarting 2008 Yamaha R6 Motor #322Yamaha R6 Engine Rebuild Part 3: Head Install & Final Steps | Partzilla.com4.0 jeep Engine rebuildYamaha R6 Engine Rebuild Part 1: Bottom End to Piston Install | Partzilla.comComplete (DETAILED) engine tear down on a 2003 cr125r / Build Part 7Yamaha R6 pt.3 CAMSHAFT CRANKSHAFT TIMINGself building R6 engineDraw Through TurboCharging (Carburetor)Motorcycle Splitting The Crank Case Pt1How-To: Change Spark Plugs and Air filter (06'-07) R604 cbr600rr clutch remove and transmission arreglo españolHow to rebuild 4 stroke engine on a dirt bike - RMZ450 buildYamaha R6 Panewki RJ09 2003-2005