Connecting the Parts (Part 2) - Wiring Preparations
In this lesson you will see how the pads on the parts (RX, camara, VTX, and GPS) match the pads on the Flight Contoller board itself. You'll also learn how to prepare the receiver (tinning the wires and Soldering wires to the receiver) in preparation for connecting the receiver to the flight controller.
Видео Connecting the Parts (Part 2) - Wiring Preparations канала BuildandFlyFPV
Видео Connecting the Parts (Part 2) - Wiring Preparations канала BuildandFlyFPV
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
Get Flying in a Simulator! - VelocidroneConnecting the Parts (Part 5) - Let's Review Our Built Quad!West Coast Multirotor Club - Winter 2023 Round 1Introduction to FPV - Step 5.1 -Let’s FLY! - VELOCIDRONE (Simulator)Introduction to FPV - (Step 3 - Setting up in BetaFlight)Betaflight Setup (Part 1) - BetaFlight Download & Firmware FlashConnecting the Parts (Part 1) - Wiring DiagramsIntroduction to FPV - Step 5.2 -Let’s FLY OUTSIDE!Radio Setup For Your QuadRadio - Initial Setup & OrientationParts Of Your Quad - What To Buy?Connecting the Parts (Part 4) - Flight Controller WiringBuildandFlyFPV DIY Course Summary & What's NextRadio Setup For a SimulatorThe Fastest Way To Get Into FPV! ...3 Simple Steps!Binding The ReceiverRadio Transmitters - What radio to buy?How To Set Up Your Radio Controller For a SimulatorLiPO Battery Chargers - Charging, and StorageIntroduction to FPV - Where to From Here?Welcome to FPV!