How To Make Quadcopter+Naza Lite+Flysky FS i6+Tutorial Step by Step Full

Download software here: https://drive.google.com/file/d/1ttTtLZhsxy0nbMgCJTJx1gkNLsXqGB7D/view
Step 1: Setup Tx FS-i6
-Reset Tx, Adjust Stick, Setup Mode, ok
Step 2: Bink Key Tx to Rx
-Press Bink Key button on Tx and turn on Tx,
Jump CH7 on Rx by wire connect then connect battery to Rx,
now Tx sound ''beep-beep'', disconnect jump wire, ok
Step 3: Test signal Tx to Rx
-Turn on Tx first, connect ESC Motor to CH3,
connect battery(3S) to ESC, push stick CH3(gas) up,
now motor start, ok
Step 4: Install software assistan + setup Naza M Lite
-Connect Naza + Rx + GPS + Led + PMU +
Battery(3S) + USB Cable to Computer(PC)
-Download software + Driver Naza below,
install driver file fisrt then install Naza Assistan and
setup data mode follow me then put Naza M Lite parallel
with Ground/Land,
press Basic Cali Button, ok
Step 5: Calibration ESC Motor
-Connect battery to PMU +connect 6 wire signal of ESC to Naza +
disconnect battery of ESC and start Naza by push 2 stick down-betwen
then push CH3 up max, connect battery to 6 ESC,
now 6 ESC sound ''beep-beep-'',
push 2 stick down-betwen to off Naza,
6 ESC sound ''beep-beep-'', ok
Step 6: Reset GPS Naza
-Push stick(3-mode) up-down-up-down-up-down-up-down-up-down,
now LED Orange is on, move rotary quadcoper arrow circle to
LED orange is off and Led Green is on, ok

Видео How To Make Quadcopter+Naza Lite+Flysky FS i6+Tutorial Step by Step Full канала The King of Homemade