How to bind Frsky RX to Jumper T12
Frsky receivers can be bound to the Jumper T12 transmitter by going to model setup, selecting MULTI module type BFrsky protocol and D8 D16 or LBT(EU) protocol subtype depending on your Frsky receiver tyoe or firmware.
If you want to have maximum range you need to fine tune the transmitter to the receiver. For this you need to find the minimum and maximum frequency range at which receiver still has a link with transmitter. After you find the min and max range, calculate the middle point and enter this value into "Freq tune" setting.
Jumper T12 transmitter: http://bit.ly/Banggood-Jumper-T12-Radio-Transmitter
You can find the ultimate Frsky receivers list here: http://bit.ly/Frsky-receivers-list
Видео How to bind Frsky RX to Jumper T12 канала Montis
If you want to have maximum range you need to fine tune the transmitter to the receiver. For this you need to find the minimum and maximum frequency range at which receiver still has a link with transmitter. After you find the min and max range, calculate the middle point and enter this value into "Freq tune" setting.
Jumper T12 transmitter: http://bit.ly/Banggood-Jumper-T12-Radio-Transmitter
You can find the ultimate Frsky receivers list here: http://bit.ly/Frsky-receivers-list
Видео How to bind Frsky RX to Jumper T12 канала Montis
Показать
Комментарии отсутствуют
Информация о видео
Другие видео канала
![Jumper T12 Configuration: Initial Setup for Race Drones](https://i.ytimg.com/vi/LzDRpuMPa0I/default.jpg)
![JUMPER T12 Setup and Binding](https://i.ytimg.com/vi/uyXuH0RRxb0/default.jpg)
![Loss of signal issue with Jumper T12 Pro - how to avoid !](https://i.ytimg.com/vi/kSfkou83rOE/default.jpg)
![Jumper T12 Multiprotocol RC Controller | OPENTX AND CROSSFIRE TOO!](https://i.ytimg.com/vi/WiJjqkrzCwc/default.jpg)
![Jumper T12 Pro Radio Review, supplied by HobbyCool](https://i.ytimg.com/vi/PoKEVAOVUWg/default.jpg)
![Jumper T12 Pro OpenTX Upgrade Tutorial 🎓](https://i.ytimg.com/vi/fToW5fGwND0/default.jpg)
![Jumper T12 Full Review Binding,Menus And Test Flights](https://i.ytimg.com/vi/c_8anHOPsC0/default.jpg)
![Jumper T16 RC - Hands On Review](https://i.ytimg.com/vi/IeZRhUolsvk/default.jpg)
![Jumper T12 gimbal demo frsky xm+](https://i.ytimg.com/vi/-Nm7UsS7GaU/default.jpg)
![Jumper T12 OpenTX Transmitter Review 😍](https://i.ytimg.com/vi/23fgyrq2ZOA/default.jpg)
![How To Bind Eachine E010 to Jumper T12](https://i.ytimg.com/vi/pUCX29w-u4U/default.jpg)
![Jumper T12 vs Taranis QX7 -What is the best drone remote?](https://i.ytimg.com/vi/_27al6xr_Ro/default.jpg)
![Jumper T12 Plus review - OpenTX Multi protocol Radio Transmitter](https://i.ytimg.com/vi/yVwTe53N6TA/default.jpg)
![XK A800 RC GLIDER OVERVIEW AND BINDING TO JUMPER T12](https://i.ytimg.com/vi/88hi9iqSwKQ/default.jpg)
![Jumper T16 Crossfire and Channel Map setup](https://i.ytimg.com/vi/_csuvZsM6PQ/default.jpg)
![iRangeX - how not to make a controller](https://i.ytimg.com/vi/KSeuZGpuaSQ/default.jpg)
![FrSky Taranis X9 Lite](https://i.ytimg.com/vi/-bmsBP_l3Jw/default.jpg)
![Eachine E010 - 4 and 2 blade propeller flight duration test](https://i.ytimg.com/vi/8D6JPBF04hg/default.jpg)
![Jumper T8SG Multi-protocol Transmitter | Full Setup Tutorial](https://i.ytimg.com/vi/mq7g81EtI6M/default.jpg)
![RC Basics: Introduction to how a RC radio system works](https://i.ytimg.com/vi/LyPtzv0y5DE/default.jpg)