The Alternative was FOUND 🤑 cheap & simple FEP film vat for UV-Resin 3D printers

Laminating pouches... is composed of various layers of plastic. The harder layer (PET) is on the outside and the softer layer (EVA) is on the inside, the harder outer layer is usually made from PET plastic (Polyethylene Terephthalate) and the softer inner layer is made out of EVA plastic (Ethylene-Vinyl Acetate)

it's important that you use only PET laminating pouches - harder laminating pouches
(PETG laminating pouches does not fit - to soft & scratches very easily)

PET...as much as 200 times stronger than glass
PET-sheet is virtually unbreakable and also has very high impact strength.

Laminating Pouches - chemical resistant and super transparent.
all you need - dissolve EVA side in the oven (make transparent by oven heat)
PET side down to the kitchen paper - when you put in the oven (200c degrees wait time 4sek)

when you attach Sheet to resin-vat, make PET side up and EVA side down
(The PET side must be in contact with the UV-resin)

UV Post Curing Temperature is 60-65 deg C using 405nm UV Light.
PET melts at 260 deg C

My settings for the Micromake L2 / Flsun S & Monocure 3D Rapid Resin
First Layer Time 50000
Num Bottom Layers 3
Layer Height 0.05
Layer Time 15000

buy here FLSUN S 3D printer https://www.gearbest.com/3d-printers-3d-printer-kits/pp_1604880.html?lkid=14680974
#GBTool #UVresinVAT #Medelis3D #3Dprinting #SLA3d #DIY #3Dprinter

Видео The Alternative was FOUND 🤑 cheap & simple FEP film vat for UV-Resin 3D printers канала Roland Med.