Making of: Dremel / Proxxon drill holder for mini lathe

Hy There,

This time i will show how easy is to make another tool for mini lathe, so you can install dremel or proxxon mini drill into.
This piece is really easy to make but it's more usefull than you think until you make it and start using.
I already got one before but it was make in a few minutes so it's not look so good, plus it was from steel, and it was all rusty and heavy, but the biggest problem on steel one was that you really hard tighten the drill into, because steel was to strong to band.
This time i make out of aluminium and anodise it to nice finish, and also you just can't use that much force on 100W drill to band 10mm aluminium holder.

Thanks for watching.

Hope you enjoy in video and welcome to watch my other channel:

Tintek33_other
https://www.youtube.com/channel/UCk9akKpWakv8Gi8wyNPnPHA

Tine Sedej:
https://www.youtube.com/channel/UCNwj7T3yDfUbmARRHERF8QA
Foto, video & editing: Tine Sedej
Camera: Sony A6500, Sony A6000
Music is from YouTube audiolibrarry:

Namaste ,Audionautix

Skladba Namaste izvajalca Audionautix je licencirana z licenco Creative Commons Attribution (https://creativecommons.org/licenses/by/4.0/)
Izvajalec: http://audionautix.com/

Видео Making of: Dremel / Proxxon drill holder for mini lathe канала TinC33